[mrtg] Re: Graph suddenly drops to zero for Gigabit Ethernet Interfaces if it exceeds 110Mbps

[Dez Cadena]

N Guruprasad wrote:

>Hi all,
> I am using MRTG-2.12.2 version.
>
>I am monitoring traffic for Gigabit Ethernet interfaces  in 7206 Cisco
>router .In the graph if the traffic is  more than 110Mbps. It suddenly drops
>to zero or near to zero .In router it shows the traffic is 135Mbps .But in
>the graph it shows only 25Mbps and  the data shown below png image is also
>25Mbps.(both incoming and outgoing drops after 110Mbps)
>
>
>How to fix this problem? So that the graph is continuous without any drop
>and data statistics should show the correct bandwidth(if it is 135Mbps i
>should display 135Mbps)
>
>Can i use current version MRTG-2.13.1 to fix this?
>  
>
you probably just need to enable SNMPv2c for those hi speed interfaces
look for SNMPv2c in 
http://people.ee.ethz.ch/~oetiker/webtools/mrtg/doc/mrtg-reference.en.html

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi