[mrtg] Re: Question about graphs maxing out

[Syed Waqqas Ahmed]

hi,
    This is quite common issue if the traffic values are increasing 100 
Mbps you starting to get no value when values increases from 100 Mbps , 
in single interface of over 100 Mbps monitoring we usually add :::::2 
in the end of target 

  example : 

  Target[ANY]:  <index>:<community>@<ip address>:::::2

  Hope it solves the problem... i have already posted the same issue b4

Steve Prosser <steve.prosser at SMU.CA> wrote:
  Content-Type: text/plain;
charset="us-ascii"
Content-Transfer-Encoding: 7bit
On one of our graphs, the scale never goes above 108 M, even though it is a
gig interface. When the traffic exceeds 108 M, it drops the graphed line
down, and continues on from the baseline. See the graph below. Does anyone
have any ideas?









Steve Prosser

Technology Analyst

Saint Mary's University










-- Attached file removed by Ecartis and put at URL below --
-- Type: image/jpeg
-- Size: 39k (40958 bytes)
-- URL : http://lists.ee.ethz.ch/p/05-image001.jpg


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive http://lists.ee.ethz.ch/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://lists.ee.ethz.ch/lsg2.cgi



 Send instant messages to your online friends http://uk.messenger.yahoo.com 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi