[mrtg] APC Amp Return

[Mehandiratta Akash]

Plz tell me the configuration to see the GIG Interface graphs.

Regards

Akash Mehandiratta
Internet Data Center- New Delhi
Network & Services Operations

Dir

(91) (11) 66505001

Email

akash.mehandiratta at vsnl.co.in

Web

http://www.vsnl.in

 

-----Original Message-----
From: mrtg-bounces at lists.oetiker.ch
[mailto:mrtg-bounces at lists.oetiker.ch] On Behalf Of Scott Ocken
Sent: Tuesday, January 15, 2008 9:43 PM
To: mrtg at lists.oetiker.ch
Subject: Re: [mrtg] APC Amp Return


You want to look at:

Factor[x]: 0.1
YTicsFactor[x]: 0.1

Scott

Quoting Sean Cheesman <scheesman at caeveo.com>:

> Hi All,
>
> I am using MRTG to get the Amp draw from twp AP7941's.  The number   
> returned is actually a three digit number (107), whereas the actual   
> Amperage draw is a two digit plus decimal (10.7).  I thought it   
> would be easy enough to convert by dividing by ten, and have tried   
> doing the conversion on the target line by both a "/ 10" and "*   
> 0.1", but the result always comes back as a two digit rounded up (11  
>  in this case).  Can anyone clue me in on how to "convince" MRTG to   
> use the full calculated result?  I feel like I'm missing something   
> obvious here, but I can't figure it out...
>
> Sean
>
> _______________________________________________
> mrtg mailing list
> mrtg at lists.oetiker.ch
> https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
>