[mrtg] riverstone

[Dowling, Steve]

Nicolas,

I guarantee that mrtg works just fine with Riverstone equipment.  Mine do.  
If getif gives you a good response, then you will get a good response from mrtg.  

Hmm....you say no response from getif.  
That normally means a bad community string (in my case).  You say 
that you get a hit on the acl when you poll?  

I'd possibly start looking at routing or firewalling or acl's at this stage.

If you need help with the riverstone config, email me offlist.


Steve Dowling
 

> -----Original Message-----
> From: mrtg-bounces at lists.oetiker.ch 
> [mailto:mrtg-bounces at lists.oetiker.ch] On Behalf Of Nicolás Quesada
> Sent: Wednesday, 26 August 2009 08:22
> To: Steve Shipway
> Cc: mrtg at lists.oetiker.ch
> Subject: Re: [mrtg] riverstone
> 
> thanks a lot. so clear. i'll follow these steps.
> 
> only one more question: can i change the SNMP version value in GETIF?
> i cannot find where
> 
> thanks a lot!
> 
> On 8/26/09, Steve Shipway <s.shipway at auckland.ac.nz> wrote:
> > It looks to me very much that you have either (1) the wrong SNMP 
> > community, or, more likely, (2) the device ACLs are not set 
> as you think they are.
> >
> > Since even getif and snmpwalk don't work, its not a MRTG or 
> cfgmaker issue.
> >
> > Since someone else is doing this successfully, the device clearly 
> > supports SNMP.
> >
> > Check the following -
> > 1. The device has SNMP enabled, but maybe it only have 
> SNMPv2 enabled?  
> > Try doing a walk with SNMPv2c rather than SNMPv1 2. Check 
> the ACLs - 
> > maybe that community is only enabled for certain IP addresses?
> > 3. Find the person who has working SNMP - get them to take 
> a look at 
> > your config :).  Ask them which SNMP version they are 
> using, who set 
> > up the router, etc.
> > 4. Possibly there is a firewall between you and this router that is 
> > blocking SNMP?
> >
> > Steve
> >
> >
> 
> _______________________________________________
> mrtg mailing list
> mrtg at lists.oetiker.ch
> https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
> 
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.409 / Virus Database: 270.13.63/2316 - Release 
> Date: 08/25/09 18:07:00
> 
**********************************************************************
This message is intended for the addressee named and may contain
privileged information or confidential information or both. If you
are not the intended recipient please delete it and notify the sender.
**********************************************************************