[mrtg] new interface setup

McDonald, Daniel (Dan) Dan.McDonald at austinenergy.com
Thu Feb 15 17:28:57 CET 2018

It's unusual to have an authentication password without a privacy password.  The default is md5 for authentication and des for privacy, so you may need to specify the authproto and/or privproto as well, as most modern devices default to sha and aes128.

On 2018-02-14, 13:03, "mrtg on behalf of Niall O'Reilly" <mrtg-bounces+dan.mcdonald=austinenergy.com at lists.oetiker.ch on behalf of niall.oreilly at ucd.ie> wrote:

    On 13 Feb 2018, at 17:51, Jon Schwendemann wrote:
    > config issue between the device and my command?
    The cfgmaker tool is independent of any running MRTG configuration.
    You seem to have some discrepancy between the SNMPv3 credentials your 
    command is using and those required by your device.  For debugging this 
    problem, it may be less trouble to use the snmpwalk tool rather than 
    cfgmaker. You can then use the latter when you have established which 
    values you need to use in your command so as to satisfy the device.
    Best regards.
    Niall O’Reilly
    mrtg mailing list
    mrtg at lists.oetiker.ch

More information about the mrtg mailing list