> I am running MRTG on a cisco Catalyst 2924XL switch.  The switch has
> been VLAN'ed into 3. Ports 1-8 on VLAN1, ports 9-16 on VLAN2 and ports
> 17-24 on VLAN3. For some reason MRTG only runs on the ports in VLAN1. It
> shows zero traffic going through all the other ports that are in VLAN's
> 2 and 3.
> 
> Any ideas on what the proper info is to have it run stats on the 2nd and
> 3rd VLANS??
> 

Not that I have any experience with this switch but I know that
to access the _bridge_ OIDs on an catalyst 5500 you could use the
community string appended with @2 and @3.
Perhaps something similar will do for you.

Thus, if your community string is "public":
snmpwalk switch public@3 .....

HTH
Alex

--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request@list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg