[rrd-users] Re: Showing a small piece on a long time graph

[Alex van den Bogaerdt]

On Thu, Oct 14, 2004 at 01:59:23PM +0400, skenga wrote:
> I'm plotting graph representing state of cisco ports, almost always
> its up and very seldom down. I draw one line, green when up and red
> when down. The problem is - when I plot for time more then 12hours my
> red doesn't shows at all, its too small I guess. How can I make it
> visible? R.

You probably have a CDEF looking at "uptime" or so and check if uptime
is zero.

When "uptime" is consolidated, it will become something else than
100% or 0%.

Don't look for " equal to 0 ".  Look for " not equal to 100% ".

HTH
Alex
-- 
You want an answer?  You'd better follow the following guidelines!
Linesize well below 80 chars. Reply to the list, not to me. Trim
irrelevant lines. Reply _below_ the relevant lines, not on top.

--
Unsubscribe mailto:rrd-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:rrd-users-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/rrd-users
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi