[rrd-users] Re: Missing data entries

[Dan Amitai]

Hi

The heartbeat matches the update time frames.
What tolerance does RRDtool have for offsets? (in the example you can
see that both examples have an offset of +2 seconds, yet one is
accepted, and the other is not.)
Can I tune the tolerance?

Thanks,
Dan

-----Original Message-----
From: rrd-users-bounce at list.ee.ethz.ch
[mailto:rrd-users-bounce at list.ee.ethz.ch] On Behalf Of Alex van den
Bogaerdt
Sent: Thursday, December 28, 2006 4:23 PM
To: rrd-users at list.ee.ethz.ch
Subject: [rrd-users] Re: Missing data entries

On Thu, Dec 28, 2006 at 09:06:09AM +0200, Dan Amitai wrote:

> Why do I get two sets of each? Why are values NaN although the command
> line parameters seem OK?
> 
> BTW the timestamp in this case is 2 seconds gap to the required update
> time. And usually, not more than a few seconds.

You used an odd way to describe your problem.  From what I could tell,
you
have a heartbeat setting that closely matches your step size.
"Not more than a few seconds" can still be "too much".

HTH
-- 
Alex van den Bogaerdt
http://www.vandenbogaerdt.nl/rrdtool/

--
Unsubscribe mailto:rrd-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:rrd-users-request at list.ee.ethz.ch?subject=help
Archive     http://lists.ee.ethz.ch/rrd-users
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi

--
Unsubscribe mailto:rrd-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:rrd-users-request at list.ee.ethz.ch?subject=help
Archive     http://lists.ee.ethz.ch/rrd-users
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi