[smokeping-users] Re: 0.99.9 is out

[Paul C. Williamson]

Folks,

In some instances, I have previews where no numbers are show.  There 
are other previews where the number show is the last whole "tick" on the 
graph.  For example, I have two routers where one of them shows 100 m, 
but the red line is slightly above.  Going into the detail for the graph shows 
that the average is 109.1 ms.  In the device right below, there are no numbers 
shown, and the average is 86.6.  I would have expect an 80 m to appear, but no such luck.  I thought the "unison_tolerance" would have shown these 
two graphs similar.  In other words, even though the one has an average 
response of 86.6, it would show the same upper limit (100 m), but just 
have drawn the red line lower in the graph.  Make sense?

At the very least, it should show 80 m in the preview, which it does not.
Is this correct?  

Paul

>>> Tobias Oetiker <oetiker at ee.ethz.ch> 01/16/02 06:03PM >>>

Folks,

I have implemented a logarithmic and a unison_tolerance variable
...

the new release is available on
people.ee.ethz.ch/~oetiker/webtools/smokeping/pub

tobi


-- 
 ______    __   _
/_  __/_  / /  (_) Oetiker, ETZ J97, ETH, 8092 Zurich, Switzerland
 / // _ \/ _ \/ / phoneto:+41(0)1-632-5286  faxto:+41(0)1-632-1517
/_/ \.__/_.__/_/ oetiker at ee.ethz.ch http://google.com/search?q=tobi 



--
Unsubscribe mailto:smokeping-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:smokeping-users-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/smokeping-users
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi