[smokeping-users] Relation between step, pings and graphs

[Kopecny Michal]

I see. Thanks a lot.

Regards,

Michal

-----Original Message-----
From: Chris Wilson [mailto:chris at aptivate.org] 
Sent: Tuesday, December 02, 2008 4:02 PM
To: Peter Kristolaitis
Cc: Kopecny Michal; smokeping-users at lists.oetiker.ch
Subject: Re: [smokeping-users] Relation between step, pings and graphs

Hi Michal,

On Tue, 2 Dec 2008, Peter Kristolaitis wrote:

> Step = how many seconds each round of polling lasts
> Pings = how many pings are sent to each target during each step
> 
> In terms of relation to RRD,
> 1 step = 1 data point in the RRD file
> 
> Note that you should set the values such that you can ping each target

> on your network 'pings' times within 'step' seconds, otherwise you
will 
> end up with blank data points in your graph.
> 
> For my production setup, I use step = 180, pings = 20.  In practice
this 
> means that each data point in the RRD file/graph represents a 3-minute

> timespan with aggregate data from 20 ping results.

Just to add a bit more to this: the default interval between pings is 1 
second. Unless you hack the FPing.pm to change this, that means that 3 
pings will take 3 seconds, and therefore step must be greater than 3 (it

might just about squeeze in with step = 3 but it will not be reliable).

Also you will not get a very good smoke effect with pings < 15. I'd 
recommend at least step = 60 and pings = 20.

Cheers, Chris.
-- 
Aptivate | http://www.aptivate.org | Phone: +44 1223 760887
The Humanitarian Centre, Fenner's, Gresham Road, Cambridge CB1 2ES

Aptivate is a not-for-profit company registered in England and Wales
with company number 04980791.