[mrtg] Re: atm pvcs on cabletron 8000

[Chris Piety]

We have not had much success with the Enterasys 6500 product and according
to support there is not likely going to be an equivalent OID available for
the ifin or ifout stats. However our Ethernet switches with the ATM SAR do
have an interface showing  for the PVC that we graph with mrtg -see
attachment. We
have not yet purchased the SSR ATM blade but if it is only working as a SAR
I
would assume you could get the same stats as on any other Ethernet switch
with a ATM interface.

Chris Piety
Middle Tenn. State Univ.



----- Original Message -----
From: "johnattan c.p." <johnattan at ihlas.net.tr>
To: "mrtg-list" <mrtg at list.ee.ethz.ch>
Sent: Tuesday, November 28, 2000 5:22 AM
Subject: [mrtg] atm pvcs on cabletron 8000


> I attempted to use mrtg for our atm pvc & frame relay lines on cabletron
8000. when i run cfgmaker with the option --ifref=ip it found the ports but
all of them were commented out (as i described a few days before by
"cabletron 8000" subject). than i tried it without writing any ifref option,
and mrtg could be able to read from the ports but it reads the 34 Mbps atm
port totally although it has pvcs & frame relays on it. can you help me
about this problem and i think cabletron is not so supported by mrtg, ha ??
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
>
>


-- Attached file removed by Listar and put at URL below --
-- Type: text/html
-- Size: 7k (8019 bytes)
-- URL : http://www.ee.ethz.ch/~slist/pantomime/ATM LEC 802_3 Port.htm


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi