[mrtg] Is it possible to make an operation on the target ?

gaetan.claeys at MOBILE.BELGACOM.BE gaetan.claeys at MOBILE.BELGACOM.BE
Fri Aug 20 14:52:16 MEST 1999

Thanks to all for your help. I can now monitor my probe (Humidity &
Temperature values).
Humidity values are from 0 to 100, temperature values are from -400 to 500
(right temperature is obtained by dividing the result by 10).

In order to represent the both values on the same graphic, I use as target :

Target[thbgt01]: at thbgt01

Is it possible to modify the target in order to obtain Humidity &
Temperature/10, so that temperature  values are from -40 to +50 ?


PS: Here is my actual MRTG configuration

Target[thbgt01]: at thbgt01
MaxBytes1[thbgt01]: 100
MaxBytes2[thbgt01]: 500
Options[thbgt01]: gauge, nopercent
YLegend[thbgt01]: Humid & Temp
ShortLegend[thbgt01]: .
Legend1[thbgt01]: Humidity value : 0 to 100 %
Legend2[thbgt01]: Temperature value : -400 to 500 Degrees (Must be divided
by 10 !)
LegendI[thbgt01]:  Hum:
LegendO[thbgt01]:  Temp:
Title[thbgt01]: THBGT01 Probe
PageTop[thbgt01]: <H1>Probe values : Humidity & Temperature
   <TR><TD>System:</TD><TD>BGTower DC Proximus -1 : Probe</TD></TR>
   <TR><TD>Maintainer:</TD><TD>Claeys G 205.26.77</TD></TR>

* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg

More information about the mrtg mailing list