[mrtg] Re: OID definition

[Elsie Simonton]

Where then do I find the second OID that I need?  From what I understand the system cannot track just one OID thus I need the other.  How do I know what this one is tracking.  It shows me a number that looks comparable to the number of users logged into the modem bank.


>>> "David C Prall" <dcp at dcptech.com> 11/09 10:57 AM >>>
> Hello again:
> I am starting to understand this and have come to the conclusion that
the double OID does not work in my setup.  Here is my target:
> .1.3.6.1.4.1.429.4.2.1.10.0&.1.3.6.1.4.1.429.4.2.1.10.0:XXX.XXX.XXX
> This does not bring any info.  I think that the reason for this is
because we are looking into the number of users on a modem bank at a
time.  And the two numbers are crossing each other out (since they are
the same).
> Thus we should only need one number.  I can just use one OID number
for the snmpwalk and snmpget but when I only enter one OID in the
mrtg.cfg it does not work.
> Thus where do I need to be looking in order to get just the amount of
users logged into the modem bank???

Get rid of the leading dot to begin with. MRTG requires an In and an Out
value. By using the same OID for both you will get a Solid Green with a
blue line along the top edge.

David C Prall, MCNE MCSE          DCP Technologies
dcp at dcptech.com                       Alexandria, VA
dcppage at dcptech.com               http://www.dcptech.com 


--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch 
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg 


--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg