[mrtg] Cisco line speed problem

[Wiek, Niels]

Hi,

We use cisco 3640 and 2611 routers. I have installed mrtg on a Windows NT
workstation. It run smoothly.  The only problem I have is that the serial
line speeds aren't correct. We use 2 Mbps lines these lines are split in two
for telephony and data transmission. For data we have 384 Kbps to the most
locations.

The problem is that when I look at the HTML pages made by mrtg created, the
linec speed says: 256 kBytes/s (ppp). This is not correct !!!
When I use the line to the max mgrt tell's me that current in and out bytes
14%.

This is not nearly 100%

Please help me.

If you need more info please ask.

Niels Wiek
e-mail: niels.wiek at epon.nl


 
----------------------------------------------------------------------------
-
>From the router this interface has 384 Kbps connection
This is the max I think look at this here

ep-hk-gba-rou-0001#sh int s1/0
Serial1/0 is up, line protocol is up
  Hardware is M4T
  Internet address is 130.3.2.1/24
  MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec, rely 255/255, load 45/255
  Encapsulation PPP, crc 16, loopback not set, keepalive set (10 sec)
  LCP Open
  Open: DECCP, IPCP, CDPCP, IPXCP
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0 (size/max/drops); Total output drops: 5766
  Queueing strategy: custom-list 1
  Output queues: (queue #: size/max/drops)
     0: 0/20/0 1: 0/20/0 2: 7/20/5762 3: 0/20/0 4: 0/20/0
     5: 0/20/0 6: 0/20/0 7: 0/20/0 8: 0/20/0 9: 0/20/0
     10: 0/20/0 11: 0/20/0 12: 0/20/0 13: 0/20/0 14: 0/20/0
     15: 0/20/0 16: 0/20/0
  5 minute input rate 305000 bits/sec, 43 packets/sec
  5 minute output rate 363000 bits/sec, 46 packets/sec
     4793221 packets input, 1741843636 bytes, 0 no buffer
     Received 1 broadcasts, 0 runts, 0 giants, 0 throttles
     36 input errors, 19 CRC, 0 frame, 0 overrun, 0 ignored, 17 abort
     7331352 packets output, 2477545834 bytes, 0 underruns
     0 output errors, 0 collisions, 6 interface resets
     0 output buffer failures, 0 output buffers swapped out
     16 carrier transitions     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg