[mrtg] Re: mrtg and cisco cwsi

[Thomas Brian Granier]

The most obvious solution that comes to mind is that MRTG might be (as
it does by default) monitoring Bytes and you are perhaps comparing bits
when you say that it it is not graphing enough traffic.

Also, if you are correct in guessing that the CWSI resets it's value
after its read then using the Option absolute on the target will fix
this problem.

T. Brian Granier
CCNA MCSE MCP+I A+
Telecommunications Specialist
Zebec Data Systems


-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Alexander.Tastler at leica-geosystems.com
Sent: Monday, August 14, 2000 11:10 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] mrtg and cisco cwsi





To:   mrtg at list.ee.ethz.ch
cc:
Subject:  mrtg and cisco cwsi

hi folks,

i am expiriencing problems when using mrtg and cwsi at the same time.
mrtg stats
show wrong values (far below the real traffic !). i could imagine that
cwsi
reads out the values and resets them (?!?). i already tried some
newsgroups, but
nobody had an answer.

did anyone ever have the same problem? how did you fix it ?

thanks
alexander

**************************************************
Alexander Tastler, IT Communication Systems
Leica Geosystems AG, CH-9435 Heerbrugg
Tel. +41 71 727 3999  Fax +41 71 726 5999
Internet:  alexander.tastler at leica-geosystems.com
*********** www.leica-geosystems.com *************



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi