[mrtg] Thresh Holds on NT

[Miller Anthony (RBAU/ISY)]

Good morning guru's (or afternoon for some)

I was wondering whether if any of you had ever seen a message like this
before.....

"The process was trying to write to a nonexistant pipe"

I get this message 5 times before the mrtgkick.bat finishes, and only after
running the
.cfg that contains the ThreshProgO commands.

(2.8.3/NTSP4)

I only get this if the ThreshMaxO is reached and the batch file is called 
using ThreshProgO. If the threshhold has not been reached I do not
get this message at all.

The batch file called by ThreshProgO seems to run fine. I can force it to
run by
dropping the ThreshMaxO value and I think all is well.

Here is a sample if the suspect .cfg

Target[nz]: 8:public at xxx.xxx.xxx.xx
MaxBytes[nz]: 1000
AbsMax[nz]: 16000
Title[nz]: PVC to Auckland (BT-CISCO-2500)
PageTop[nz]: <H1>Traffic Analysis for Serial0.5
 <BR> PVC to Auckland </H1>
 <TABLE>
   <TR><TD>System:</TD><TD>BT-CISCO-2500</TD></TR>
   <TR><TD>Maintainer:</TD><TD>BT Australiasia</TD></TR>
   <TR><TD>Interface:</TD><TD>Serial0.5 (8)</TD></TR>
   <TR><TD>Max Speed:</TD>
       <TD>8K CIR  (frame-relay)</TD></TR>
  </TABLE>
Options[nz]: bits
WithPeak[nz]: ymw
UnScaled[nz]: ymwd
ThreshMaxO[nz]: 1000
ThreshProgO[nz]: c:\mrtg-2.8.3\run\ThreshOverNZ.bat


Comments?

regards
Anthony Miller
===============================
Network Engineer
Information Systems Department
Robert Bosch (Australia) Pty. Ltd.
1555 Centre Road, Clayton, Victoria, Australia, 3168
Tel. : +61 3 9541 7824          Fax : +61 3 9541 5284
E-mail : anthony.miller at au.bosch.com


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:mrtg-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/mrtg