[mrtg] Re: Inaccurate Results

[Shpend Bakalli]

Are you measuring bits or bytes?
By default MRTG measures in bytes. In this case you have to multiply by
8 in order to get the value in bits/s. You can adjust MRTG to show the
values in bits through the Options command.

Regards,
Shpendi

Jeroen Geusebroek wrote:

> Hi there,
>
> I downloaded and installed mrtg-2.8.12 yesterday and i must say
> it's a very nice program. I only have one problem; the results
> that mrtg gives me are not accurate.
>
> I am on a 100Mbit network, but mrtg tells me there has only been
> a max of 364kb/s of traffic. This is not correct, because i was
> downloading from an FTP site with 7000+kb/s for about 10 minutes.
>
> I am also using it to monitor other NIC's for example my internet
> connection. This also does not show accurate results.
>
> What could be the problem? I am using Linux Mandrake Version 7.0-2.
> SNMP deamon is: UCD-Snmp version 4.01
>
> Thanks in advance for any help.
>
> Regards,
>
> Jeroen Geusebroek
>
> P.s. The results can be seen on http://www.intercept.cx/mrtg
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi