[mrtg] Re: Graph scaling

[Paul C. Williamson]

I *think* you can set your MaxBytes to 2 and remove AbsMax.  The only benefit you have from AbsMax is there should be a dotted red line through the MaxBytes when the data gets that high.  If you set the MaxBytes to 2, your graph will show high all the time, and it should top out at 2.  AbsMax is the setting that is causing it to show 4.  

Paul

>>> <Chuck.Curto at tmcaz.com> 06/06/00 10:38AM >>>
I didn't get a response from this so I thought I would try one more time.

I'm monitoring a power supply in a Cisco Catalyst 5500 switch. The result I
get back from MRTG is a "1" meaning the power supply is off, or a "2" meaning
it's on.

Even though I set my MaxBytes and AbsMax to 2, the top of my graph scale is 4
(I don't know why). How can I get the graph to show a maximum of 2?


Chuck Curto
TMC HealthCare
chuck.curto at tmcaz.com 


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe 
Archive     http://www.ee.ethz.ch/~slist/mrtg 
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org 



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org