[mrtg] MRTG 2.8.12: Monitoring more than 2 variables

Nicholas Ritter ritter at lfc.edu
Fri Jun 30 19:14:19 MEST 2000


I have seen this on one of the sites listed in the MRTG site map, where more
than 2 SNMP variables are being graphed.

Every time I try to do this I get an error. I am using the
OID&OID:community at device  syntax. But when I try to do
OID&OID&OID:community at device I get the error.


The error I get is a SNMP noSuchName error. If I am asking for the following
OIDs:

1.3.6.1.2.1.2.2.1.10
1.3.6.1.2.1.2.2.1.12
1.3.6.1.2.1.2.2.1.18

In the following syntax:
1.3.6.1.2.1.2.2.1.10.2&1.3.6.1.2.1.2.2.1.12.2&1.3.6.1.2.1.2.2.1.18.2:public@
deviceaddress

(I append an interface number to the end of each of course)

I get the following error:

SNMP Error:
Received SNMP response with error code
    error status: noSuchName
    index 2 (OID: 1.3.6.1.2.1.2.2.1.12.2.3.6.1.2.1.2.2.1.18.2)
SNMPv1_Session (remote host...
....blah
....blah
....blah
SNMPGET Problem for 1.3.6.1.2.1.2.2.1.10.2
1.3.6.1.2.1.2.2.1.12.2&1.3.6.1.2.1.2.2.1.18.2 sysUptime SysName ifDescr.2 on
public at deviceaddress
SNMPGET Failed to reach target:
"1.3.6.1.2.1.2.2.1.10&1.3.6.1.2.1.2.2.1.12.2&1.3.6.1.2.1.2.2.1.18.2:public at d
eviceaddress". I tried multiple times!


Is there a way to graph more than 2 variables, and if so, how?


Nicholas Ritter
Network Administrator, LFC


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



More information about the mrtg mailing list