[mrtg] How I do config ports for CISCO 3800

[edmundli]

we have Cisco 3800 router, and we would like to use MRTG to monitor servial ports, how can we do this ? 

I try cfgmaker 1:my community name at router >> mrtg.cfg
but it did not work. 


Cisco:
Ethernet0 is up, line protocol is up 
Loopback0 is up, line protocol is up  
Serial0 is up, line protocol is up  
Serial0.1 is up, line protocol is up
Serial0.2 is up, line protocol is up

I think the most important one is Serial0, since it has 512k line to ourside

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
     reliability 255/255, txload 11/255, rxload 18/255
  Encapsulation FRAME-RELAY IETF, crc 16, loopback not set
  Keepalive set (10 sec)
  Scramble enabled
  LMI enq sent  37434, LMI stat recvd 37421, LMI upd recvd 0, DTE LMI up
  LMI enq recvd 0, LMI stat sent  0, LMI upd sent  0
  LMI DLCI 0  LMI type is ANSI Annex D  frame relay DTE
  Broadcast queue 0/64, broadcasts sent/dropped 62134/2, interface broadcasts 49
656
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters 4d07h
  Queueing strategy: fifo
  Output queue 0/1024, 59 drops; input queue 1/1024, 0 drops
  5 minute input rate 112000 bits/sec, 83 packets/sec
  5 minute output rate 70000 bits/sec, 71 packets/sec
     12989068 packets input, 3513773823 bytes, 0 no buffer        

How are can set differnet port ? 






===================================================================
·s®ö§K¶O¹q¤l¶l½c http://sinamail.sina.com.hk 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:mrtg-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/mrtg