[mrtg] Re: How can I...

[Mohammed, Hadiza L]

Dayton,

To make the chart look better, you could add the line

MaxBytes[xxxxx.1]: <value> 

where value is 1.54 Mbits divided by 8 to give you the bytes. That gives you
a dotted red line on the chart indicating the full T1 bandwidth.

Hope this helps,
Hadiza


-----Original Message-----
From: Dayton Jones [mailto:daytonj at netdrive.com]
Sent: Wednesday, May 03, 2000 1:32 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] How can I...


I'm sure this has been asked many times but I didn't see it in the
archive.

I'm using MRTG to poll a Cisco 2514 to watch my company's T1 bandwidth.

	Options[xxxxx.1]: growright,unknaszero,bits

this is working great except that the graphs show the increments in
kb/s...what I want is for them to say mb/s...so that when we are using the
full 1.54M the chart shows 1.5M instead of 1600.0k

I tried using 
	kilo[xxxxx.1]: 1024 
but it seemed to make no difference....what can I do to resolve this?
Thanks in advance for any help offered.

-- 

Dayton Jones
daytonj at netdrive.com            |       System Administrator,
http://www.netdrive.com         |       netdrive.com, Inc.
ph. (408) 399-1882 x109         |       985 University Ave, Suite 8
fx. (408) 399-1884              |       Los Gatos, CA 95032

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org