[mrtg] Re: Bandwidth Aggregation (Should this Work?)

[Brian E. Seppanen]

On Mon, 13 Nov 2000, Enerson, Marty wrote:

>
> I'm trying to set up a config that will add the utilization of two
> interfaces.  I continue to get a configuration error.  Is there something
> wrong with this config?  I've tried it a whole lot of different ways, and
> none have worked.
>
> Target[bandwidth]:
> ifInOctets.1&ifOutOctets.1/xxx.xxx.xxx.xxx:public at xxx.xxx.xxx.xxx +
> ifInOctets.1&ifOutOctets/xxx.xxx.xxx.xxx:public at xxx.xxx.xxx.xxx
>
> I have tried this in a format similar to the mrtg configuration
> reference.  I have tried just adding up the InOctets.  I can snmpwalk
> just fine.  Everything is working just dandy otherwise.

The first problem I had was  that I didn't have my WorkDir set
in my test config.  However, even after correcting that I still can't get
any data.  A graph generates but it contains no data.  At this point I've
pared it down to

 port:string at ip + port:string at ip, etc.

Will it make any difference if I'm using rrdtool versus rateup and logfile
formats?

Thanks,
Brian Seppanen
Regional Data Center
Charter Communications
Marquette, Michigan



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi