[mrtg] Re: Bandwidth Aggregation (Should this Work?)

[Enerson, Marty]

Don't you need a ".1" after the second "...ifOutOctets"

ifInOctets.1&ifOutOctets/xxx.xxx.xxx.xxx:public at xxx.xxx.xxx.xxx
                       ^
                       ^
                       ^

Just a thought.

Marty 



-----Original Message-----
From: Brian E. Seppanen [mailto:seppy at chartermi.net]
Sent: Monday, November 13, 2000 2:50 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Bandwidth Aggregation (Should this Work?)



I'm trying to set up a config that will add the utilization of two
interfaces.  I continue to get a configuration error.  Is there something
wrong with this config?  I've tried it a whole lot of different ways, and
none have worked.

Target[bandwidth]:
ifInOctets.1&ifOutOctets.1/xxx.xxx.xxx.xxx:public at xxx.xxx.xxx.xxx +
ifInOctets.1&ifOutOctets/xxx.xxx.xxx.xxx:public at xxx.xxx.xxx.xxx

I have tried this in a format similar to the mrtg configuration
reference.  I have tried just adding up the InOctets.  I can snmpwalk
just fine.  Everything is working just dandy otherwise.

I saw that someone mentioned there is the possibility of arithmetical
operators not working properly, but I have a config that does an
arithmetical conversion of celsius to fahrenheit degrees, so I wasn't sure
if that could be a possible cause.   Any assistance, insight, would be
greatly appreciated.

Thanks

Brian Seppanen
Regional Data Center
Charter Communications
Marquette, Michigan


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi