[mrtg] Re: mrtg & 3Com CoreBuilder 9000
Fred
fhoth at ma.ultranet.com
Thu Oct 19 14:55:59 MEST 2000
Hello,
If the 3Com Corebuilder 9000 is anything like the 5000 then you have to
build the statement like this
perl cfgmaker community at vbridge_#@ip_address
so mine mine would look like this
perl cfgmaker public at vbridge_1@172.30.0.5
Hope that helps.
----- Original Message -----
From: "Vadim Stanovov" <vvs at blpk.ru>
To: "mrtg-list" <mrtg at list.ee.ethz.ch>
Sent: Wednesday, October 18, 2000 1:06 AM
Subject: [mrtg] mrtg & 3Com CoreBuilder 9000
>
> Hi!
>
> I have an 3Com CoreBuilder 9000 which have some modules.
> mrtg's cfgmaker can reach only managment module.
> But CoreBuilder 9000 have "SNMP Extensions Table" like this:
>
> 1 None 3Com CoreBuilder-9000 Enterprise Management
> Engine (3CB9EME) s/w rev: 3.0.0
> Serviced by module 9.2
> Used for managing module 9.2
> 2 @fabric 3Com Corebuilder 9000-24 Port Gigabit Switching
> Fabric, 12 Trunks v3.00.1
> Serviced by module 7.1
> Used for managing module 1.1
> Used for managing module 7.1
> 3 @slot_2.1 3Com Corebuilder 9000-10 Port 100FX Layer 2
> Switching Module v3.00.0
> Serviced by module 2.1
> Used for managing module 2.1
>
> How I should tune mrtg to monitor ports on modules via SNMP Extensions?
>
> Thanks,
> Vadim Stanovov
>
> System Administrator
> JSC "Bratskcomplexholding"
> Bratsk, Irkutsk region, Russia
> WWW: http://stanovov.com
> E-mail: mailto:vadim at stanovov.com
> ICQ: 48201071
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive http://www.ee.ethz.ch/~slist/mrtg
> FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
> WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
>
--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
More information about the mrtg
mailing list