[mrtg] Mibs

[Jim Wurster]

I have been asked to start working on some MRTG graphs for some equipment
that is completely new to me. I have a few questions about Mibs and other
equipment.

I am trying to get info for the following equipment:
ASC
CopperMountain
RedBack

I let cfgmaker do what it could but I guess you can install Mibs with the
LoadMibs command. After you do a LoadMibs and point to the mibs dir and file
do you have to change the config that was generated with cfgmaker? If so how
is this where I start using the OID directly?

Pardon my lack of SNMP knowledge trying to learn all this in a very short
time so far this list has been very helpful in answering some questions
before I even asked them.

Also if anyone else is using MRTG to graph any of the above I would like to
see what else can be done other then Bandwidth.

Thanks again

Jim


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi