[mrtg] Re: MRTG & SNMP
extml at ndsoftware.net
Wed Apr 18 18:10:21 MEST 2001
OK But it's only for the thernet traffic of my Linux RedHat 6.2 :)
I have upgraded mrtg and snmp and nothing run now :(
Nicolas DEFFAYET, NDSoftware
http://www.ndsoftware.net - ndsoftware at ndsoftware.net
France: Tel +33 671887502
Note: All HTML email sent to me can be deleted for security reasons.
From: Frank Carreiro [mailto:fcarreiro at loweryinc.com]
Sent: Wednesday, April 18, 2001 6:00 PM
Cc: Mailing-List MRTG
Subject: Re: [mrtg] MRTG & SNMP
Every manufacturer is different. Typically you would either telnet into
the device or directly connect to the management module. Usually there
is a logon and password request. On Cisco's you need to type "en" to
enter supervisor mode (again a password will be required).
I don't do this every day so I'm a bit rusty but basically on cisco I
type "show ?". A list will appear of commands. There is a section for
SNMP if I recall correctly. I simply had to follow through the menu of
commands and enable it. It wasn't terribly hard however I was digging a bit.
Wish I could give you more details. Perhaps someone more familiar with
these devices can help. I recommend you check your device
documentation. It should give details how to set it up.
> How ?
> Nicolas DEFFAYET, NDSoftware
> http://www.ndsoftware.net - ndsoftware at ndsoftware.net
> France: Tel +33 671887502
> Note: All HTML email sent to me can be deleted for security reasons.
> -----Original Message-----
> From: Frank Carreiro [mailto:fcarreiro at loweryinc.com]
> Sent: Wednesday, April 18, 2001 5:28 PM
> To: NDSoftware
> Cc: Mailing-List MRTG
> Subject: Re: [mrtg] MRTG & SNMP
> Usually when I see this SNMP isn't enabled or the community string was
> Might want to check these. Could be something as simple as enabling it
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
More information about the mrtg