[mrtg] Re: Maxbytes values

[Mike Koch]

Hi,

just split your target in two targets (a "in data" target and "out data"
target), and specify two different maxbytes. Of course, the graphs will no
longer be on the same page...



-----Original Message-----
From: jej at dansystem.dk [mailto:jej at dansystem.dk]
Sent: mercredi 8 aout 2001 11:34
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Maxbytes values

Hi!
Is there a way to make different maxbytes values for in and out data.
Eksample: a 1024/256 kbit connection. When the amount of data reaches
256kbit/sek the shown in % is of cause 25. I Know that it is because I
defined
128 Kytes/sek in maxbytes field. I wish to use 2 different 100% values, one
for
incoming and one for outgoing data.

/Jesper



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi