[mrtg] Cisco 4500: No sub interface data in CFG file.

[Smith, Phil]

Our two Cisco 4500 routers connect to approx 50 Area Office sites using
Frame Relay. I can successfully run cfgmaker against router 1 .The resulting
cfg files show all serial sub-interfaces.

When cfgmaker is run against router 2 (using the same Community sting, and
options) the cfg file shows the physical serial interfaces but no
sub-interface information. 

These routers are managed by our carrier so we have no "official" access.
However I got the current configs on both routers and have compared the two.
I can see the following differences:

IOS versions:

Router1 = 11.2
Router 2 = 11.0

Serial Interface differences:

Router1 = all Sub interfaces configured as S1.<sub interface no>
Router2 = all Sub interfaces configured as S0.<sub interface no>


Finally there are some access-list differences which I don't believe bare
relevance but can be provided if required. 

The SNMP community strings and other SNMP-related lines are identical.

Are the above differences important? If not does any-one have any ideas?

TIA

Phil Smith





**********************************************************************
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they
are addressed. If you have received this email in error please notify
the system manager.

This footnote also confirms that this email message has been swept by
MIMEsweeper for the presence of computer viruses.

www.lstrillium.com
**********************************************************************

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi