[mrtg] Re: Resolution - HP ProCurve 10BT Problems

[Chairman of the Bored]

At 08:10 PM 2/15/2001 -0500, Steve Jarrell wrote:
>
>In case anyone else runs into a HP ProCurve 10BT hub...
>
>By default, mrtg gets its in and out data from IfInOctets and IfOutOctets.
I don't know what the octets in these represent in this particular piece of
hardware, but it certainly isn't the throughput of any of the ports on the
hub. Even will almost 1Mbps going through the first port, the values from
IfIn and IfOut were only about 100-200 bytes a second.
>
>Using an snmp tool, I found  hostInOctets and hostOutOctets that had an
array containing each of the ports on the hub. By matching the MAC address
of the device that port 1 was attached to (this is the one that goes to our
ISP), I was able to determine the correct hostin and hostout OID #'s, and
set them up manually.  Works great now. Getting exactly what I expected.
>
>Steve

toss me a copy of your config file and i'll throw it in my archives...
-dd

                                \\\\\//                                    
       \\|//       _\\|//_      |     |      _\\|//_       \\|//           
       (@ @)      (' 0-0 ')     (.) (.)     (' @-@ ')      (o-o)           
+-=oOOo-(_)-oOOo=oo0=(_)=0oo=oOO=-(_)-=OOo=oo0=(_)=0oo=oOOo-(_)-oOOo=-+    
                | Level Seven inc. http://www.L7.net/ |                 /"\
   The worlds "one stop" InterNetworking Provider 1 (360) 753 - 3556    \ /
+-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-+  X 
ASCII Ribbon campaign against HTML E-Mail >- - - - - - - - - - - - - -> / \ 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi