[mrtg] Problems with OID

[Luca Micheletti]

Hi,

I use Mrtg from two years and it work very well.
These days i have a problem with an OID.
I want to monitor CRC errors on serial lines of Cisco router.
The OID is " .1.3.6.1.4.1.9.2.2.1.1.12.3" but if put this in a config file
i have an error.
The line in the  config file is:

Target[Serial_interface]: .1.3.6.1.4.1.9.2.2.1.1.12.3:public at myrouter

When mrtg work the error is this:

Scalar found where operator expected at (eval 26) line 1, at end of line
         (Missing operator before ?)
ERROR: Target[Serial_interface] eval warning: syntax error at (eval 26) 
line 1, near "12. $"

Can you help me??
Thank you for the attention.
Bye.
*******************************************
* Luca Micheletti                            *
* Network IP technician                  *
* luca.micheletti at cdc1085.com      *
******************************************


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi