[mrtg] Re: Less than 5 minutes?

[Ruiz, Gabriel [NCSLA] Non J&J]

Before tweaking the MRTG configuration to polling on intervals less than 5
finutes, you have to consider the fact that the SNMP object MRTG is polling
is based on a parameter that the router (or device) usually by default
captures in a 5 minutes interval. If you want to have polls for less that 5
minutes, you have to make changes the Managed device too. For example, in a
Cisco router you can modify that parameter by using the following command:

Bart#conf t
Bart(config)#int s0
Bart(config-if)#load-interval ?
  <30-600>  Load interval delay in seconds

The default is 300 seconds (or 5 minutes). If your equipment is not a Cisco,
your device must have a similar option.

Regards

Gabriel Ruiz 


-----Original Message-----
From: Grady Kelly [mailto:Grady.Kelly at helloNetwork.com]
Sent: Friday, January 26, 2001 1:31 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Less than 5 minutes?



How can i tweak MRTG to graph intervals less than 5 minutes??
What about every minute? second?
Anyone know where it is in the script?

Grady Kelly
Network Operations
helloNetwork.com, Inc.
702-938-9396
Cell 702-604-4150
Email: grady.kelly at helloNetwork.com


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi