[mrtg] Re: Check Systemload on a Multiprozessor Machine

[Mike Koch]

So you have two possibilities :

The easy one : just take your total load of 4 processors and divide it by 4.
Ok, you'll say me that it will be only an average value. Maybe you want the
load of each individual processor so...

The less easy one : ...so find another OID that returns the load of each
single processor through all the instances.


-----Original Message-----
From: Sandra.Krumme at Bertelsmann.de [mailto:Sandra.Krumme at Bertelsmann.de]
Sent: jeudi 12 juillet 2001 17:19
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Check Systemload on a Multiprozessor Machine



Hello,

I am using MRTG and NET-SNMP to graph the load on a Solaris machine with
four processors.
Used 0ID is =  1.3.6.1.4.1.2021.10.1.5.2&1.3.6.1.4.1.2021.10.1.5.2 which
works fine and gives
me back a value in percent.
But this value is total and results in a load of 204 % for all 4 processors.
What can I do to get
the effective load for 1 processor ?
Currently I am not using rrdtool.

Any hint for me ??

Kind regards 

Sandra


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi