[mrtg] Re: Rateup died from Signal 0

[Alex van den Bogaerdt]

petittre at zdnetonebox.com wrote:

> I get this error:
> 
> Warning: rateup died from Signal 0 with exit Value 1 when
> doing router 10.90.32.1_1 Signal was 0, Return code was 1

This is not a real signal, it is just an error in your setup.
Most likely the config file isn't correct.

> This does it for all the ports it found during the cfg process.

Have you tried cfgmaker?  Even if you don't actually use the
generated config file it can act as a template.

Start simple.  Just define one target.  Get this to work.  Only
then expand your config file.

Make sure you follow the MRTG for WIN guide when you set it up.
Make sure to use the latest version.

If this doesn't help you to solve the problem, just post a complete
config file (the small version with only one target!) and we'll all
have a look.  You seem to be using rfc 1918 addresses but alter the
community string and the ip addresses anyway if desired.

cheers,
-- 
   __________________________________________________________________
 / alex at slot.hollandcasino.nl                  alex at ergens.op.het.net \
| work                                                         private |
| My employer is capable of speaking therefore I speak only for myself |
+----------------------------------------------------------------------+
| Technical questions sent directly to me will be nuked. Use the list. | 
+----------------------------------------------------------------------+
| http://faq.mrtg.org/                                                 |
| http://rrdtool.eu.org  --> tutorial                                  |
+----------------------------------------------------------------------+

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi