[mrtg] mrtg and PIX firewall with failover

Garnel, Eric egarnel at Question.com
Wed Jun 27 17:06:42 MEST 2001

This is kind of funny I think!

I am monitoring a Cisco PIX firewall that is set up in a stateful failover
mode (using 1 nick per pix in dmz2). The ip for the failover NIC is the
loopback, so when running cfgmaker against the PIX, MRTG picks up the
failover interface as local. Off hand,  I believe I can assign a separate
subnet for failover, but I will check with Cisco just to make sure.
Just thought I would share that with you....

Eric Garnel
Network Engineer CCNA, MCSE
Question Technologies
Turning Questions into Commerce

701 Brazos Street, Suite 1200
Austin, TX 78701
512/391-4120 direct
512/480-9136 fax
egarnel at question.com
http://www.question.com/ <http://www.question.com/> 

Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

More information about the mrtg mailing list