[mrtg] subinterfaces revisited...

[Garnel, Eric]

Other than resorting to CAR, is there any way to graph sub-ints on a 3640
router?

I am running 12.1.1aT ip plus on a 3640 with a 2 100mb card (NM-2FE-2W) with
6 sub interfaces configured with ISL encap.
Is there a higher IOS rev that supports this ? 

I tried using Getif to pull the exact #'s, but am not sure if I got the
correct OIDs.
I hand edited the cfg file and ran it, but all the sub interfaces graph the
same so I suspect it is only looking at the top level int.

Eric Garnel
Network Engineer CCNA, MCSE
Question Technologies
Turning Questions into Commerce

701 Brazos Street, Suite 1200
Austin, TX 78701
512/391-4120 direct
512/480-9136 fax
egarnel at question.com
http://www.question.com/ <http://www.question.com/> 



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi