[mrtg] Re: how to configure mrtg to get data from file

[Daniel R . Kilbourne]

first install ucd-snmp (aka net-snmp) from http://net-snmp.sourceforge.net/

configure snmpd (vi snmpd.conf) per net-snmp instructions

run cfgmaker (included with mrtg) against the server to get ether stats

goto http://netophilia.net/linux-oids.html if you want to graph more


also, later today, I will add a section on configuring snmpd to that page above.


Enjoy extolled:
> hi All there
> 
> I am new to this list 
> I am new to snmp and mrtg also
> I had tryed to installed mrtg to my RH6.2 Linux server for maonitor the amount of traffic flow through
> my server with good graphs but i was unsuccesful i had been into loop with snmp and mrtg 
> I know this can be done with mrtg 
> 
> so its is an request to any one who had done it before to pls send me the detail regarding this
> 
> 
> Thanx
> 
> Regards
> 
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
> 

-- 
--------------------------------
Daniel R. Kilbourne
daniel.kilbourne at voyager.net
Network Engineering
CoreComm - Formerly Voyager.net
________________________________

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi