[mrtg] Re: general question about mrtg.cfg format

[Reed Mohn, Anders]

http://faq.mrtg.org


Always 2, if they're the same, you see only one graph,
but MRTG must always have two OID's as input.

This is how MRTG can monitor, for instance,
in and out traffic on network interfaces.

Anders :)




> -----Original Message-----
> From: Matthew Snead [mailto:syntax53 at hotmail.com]
> Sent: 9. oktober 2001 06:02
> To: mrtg at list.ee.ethz.ch
> Subject: [mrtg] general question about mrtg.cfg format
> 
> 
> 
> When I'm doing the target line, and im putting in an OID, 
> sometimes i see, 
> like for processor utilization, you put the processor OID 
> followed by an "&" 
> and then the OID again (like 
> .1.2.3.4.5.6&.1.2.3.4.5.6:public at localhost).  
> But then i notice on something like hard drive usage it would 
> have two 
> different OID strings (like 
> .1.2.3.4.5.6&.1.2.3.4.5.7:public at localhost)...  
> what do each of the positions mean?  does there always have 
> to be 2? can 
> there be 3 or more, or just 1?
> 
> thanks,
> matt
> 
> _________________________________________________________________
> Get your FREE download of MSN Explorer at 
> http://explorer.msn.com/intl.asp
> 
> 
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
> 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi