[mrtg] Re: Log file not updating

[Paul C. Williamson]

You need gauge in the Options as well.

Paul

>>> Michael Mathis <mathis at cisco.com> 09/07/01 11:09AM >>>

I am trying to monitor CPU utilization on a Cisco router.  I have 
mrtg-2.9.17 installed.  I have made configs with config maker to monitor 
bandwidth, and they work properly.  Here is the config file I am trying tou
 se to monitor CPU usage:

WorkDir: /etc/httpd/mrtg
Target[rtrA.cpu]:.1.3.6.1.4.1.9.2.1.58.0&.1.3.6.1.4.1.9.2.1.58.0:public at 170.206.225.2 
RouterUptime[rtrA.cpu]: public at 170.206.225.2 
MaxBytes[rtrA.cpu]: 100
Title[rtrA.cpu]: CPU LOAD
PageTop[rtrA.cpu]: <H1>User CPU Load %</H1>
ShortLegend[rtrA.cpu]: %
YLegend[rtrA.cpu]: CPU Utilization
Legend1[rtrA.cpu]: User CPU in % (Load)
Legend2[rtrA.cpu]: Idle CPU in % (Load)
Legend3[rtrA.cpu]:
Legend4[rtrA.cpu]:
LegendI[rtrA.cpu]:  User
LegendO[rtrA.cpu]:  Idle
Options[rtrA.cpu]: growright,nopercent

When I run MRTG, an SNMP call goes out to the router and comes back with 
the right information.  The first line of the log file is updated with thep
 roper values for CPU.  But when I rerun mrtg, the values do not filter 
down the log.  The first line just gets replaced with new values.  Does 
anyone have an idea about what's happening.  I know its probably know itss
 omething stupid but can't figure it out.

Second, if you look closely you will see that I preceded the OID's with ap
 eriod.  snmpgets work when i do this, but not if I just supply the 
OID.  Any ideas why?  I am using UCD-snmp version: 4.1.2


Thank you very much,
Michael


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe 
Archive     http://www.ee.ethz.ch/~slist/mrtg 
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org 
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi 



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi