[mrtg] Re: Monitoring 6506 blades

[Chris Burton]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

If you just run cfgmaker on the switch you can pull the complete
config down the down side to this is you will get every port, but you
can just manually edit the config and remove the ones you do not
want.

Chris Burton
Network Engineer
Disney Internet Group: Network Services
206.664.4833
425.591.4805



- -----Original Message-----
From: Robert_Mersberger at BeverlyCorp.com
[mailto:Robert_Mersberger at BeverlyCorp.com]
Sent: Tuesday, April 16, 2002 1:28 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Monitoring 6506 blades



I have a 48 port 10/100 blade in my 6506 that I would like to monitor
by
port.  I have done a snmpwalk on the 6506 but cannot find the mibs I
need to
monitor ports.  The blade is in slot 3 of the 6506 and I would like
to
monitor ports 3/1 to 3/6.  
Can anyone tell me how  to do this.  At present I am looking for
inocets and
outocets.

I though this would be the same as a 2948G but found it not to be so.

Thanks

- --
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

-----BEGIN PGP SIGNATURE-----
Version: PGP 7.0.1

iQA/AwUBPLyPdFGJUk/xhG8mEQLL+gCfUKPzQOJd7bOasFiOfG+cln62iNAAn30A
yafothA4OBjc/PAzzyPvx/lA
=/i+C
-----END PGP SIGNATURE-----


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi