[mrtg] Re: Show 3 lines in one graph

[Haspers]

No you can't. Use must use RRDTool to do that.

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Andre
Sent: donderdag 22 augustus 2002 4:01
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Show 3 lines in one graph



hi all... i have a 'little' problem..
i just success configure my mrtg. now the porblem, can i showing 3 lines in
one graph? one line for outgoing tarffic, one line for incoming traffic, and
last line for total traffic (incoming+outgoing). it's possible to do it?
i have tried adding 3 same target:
Target[test]: /10.0.0.10:public at 10.0.0.10: + -/10.0.0.10:public at 10.0.0.10:
Target[test]: /10.0.0.10.:public at 10.0.0.10:
Target[test:] -/10.0.0.10:public at 10.0.0.10:
Options[test]: bits,growright
SetEnv[test]: MRTG_INT_IP="10.0.0.10" MRTG_INT_DESCR="eth1"
MaxBytes[test]: 16000
AbsMax[test]: 24000
LegendI[test]:  Total:
LegendO[test]:

then i running the configuration, but I get the following error:
andre at andre:~/public_html/new/mrtg> mrtg test.cfg
ERROR: Line 3 (Target[test]: /10.0.0.10:public at 10.0.0.10:) in CFG
file (test.cfg)
contains a duplicate definition for target[test].
First definition is on line 2

if possible to add 3 lines in one graph, can you show the configuration? thx
before for your help.

regards,
Andre

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi