[mrtg] Re: MRTG to monitor ATM interface on Fore ESX-3810

[Phillip Lee]

Hi Greg,

Thank you for your response. I am glad to hear from someone who has it
working with these switches. I did try the atmmaker script from 2.9.17
against a ASX-1000 switch. I wish I had the same level of success as you.
Unfortunately, I only got one port and it was getting 0 count for that
interface. This is the core switch with at least 8 active OC-3 interfaces.
Did you do anything special other than run atmmaker community at fore-switch-ip
?

Thanks!!
Phil
----- Original Message -----
From: <Greg.Volk at edwardjones.com>
To: <mrtg at list.ee.ethz.ch>; <philliplee81 at attbi.com>
Sent: Monday, February 04, 2002 6:49 AM
Subject: Re: [mrtg] MRTG to monitor ATM interface on Fore ESX-3810


> > Hi all,
> >
> > I am having a difficult time getting ATM interface utilization
> > stats for my Fore Systems ATM equipment  (ASX 1000's and ESX
> > 3810's). I can monitor the Ethernet ports on the ESX-3810 using
> > cfgmaker but I don't see any stats on
> > the ATM interface. I have tried to query IfInCells but I cannot
> > seem to get any data on that port. I tried to match an OID to
> > match the CellsRcvd and CellsTrans but no luck so far. I know I
> > am getting traffic on that port from the CellsRcvd/Trans counter.
> >
> > Any help would be greatly appreciated.
> >
> > Thanks,
> > Phil
> >
>
> I use the atmmaker script that can be found in the mrtg-2.9.17/contrib
> directory to build configs for my asx-1000's, tnx-1100's, and asx-4000's.
> It works well enough - it counts cells/sec and multiplys them by 53 and
> graphs bytes per second. What it doesn't do, which would be really nice
> is break out the individual PVCs running on a particular port. That
> would be nifty because I have several OC3's that are pretty carved up
> and per-PVC utilization stats would be helpful in capacity planning.
>
> I've worked with marconi to come up with some OIDs and such for PVCs
> in the past but didn't make a whole lot of progress - most likely
> because I got busy fighting other fires (marconi tech support is usually
> quite helpful IMHO).
>


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi