[mrtg] LoadMIB:

Matt Katona mkatona at comwavz.com
Wed Jul 24 16:22:59 MEST 2002


So I am having trouble getting a Cisco MIB/OID to work. Tell me if I am crazy:

Both ends of the IP Sec tunnel are Cisco routers
Ciscos website tells me they both support IPSec-Flow and IPEncrption MIBS
I complied both mibs
I add the following line into my config:
then I add the OID to the targets where the last octect (.11) is the interface of the tunnel on the router

Run the config, no problems.. But it tells me no traffic. I have MRTG polling the tunnel interface and it records that it sees traffic going down the tunnel.. Thoughts?

Matthew Katona
Systems Engineer
O:419-859-2194 x1771
"Consistency is the last refuge of the unimaginative" tagged by Oscar Wilde (1854-1900)

Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

More information about the mrtg mailing list