[mrtg] Re: switch

[Jason Frisvold]

Try looking at ifName as well...  On the Cisco's, at least, they seem to
be populated correctly..

---------------------------
Jason H. Frisvold
Senior ATM Engineer
Engineering Dept.
Penteledata
CCNA Certified - CSCO10151622
friz at corp.ptd.net
---------------------------
"Imagination is more important than knowledge. Knowledge is limited.
Imagination encircles the world." -- Albert Einstein [1879-1955]


-----Original Message-----
From: Leonard Miller [mailto:Leonard_Miller at udlp.com] 
Sent: Thursday, June 13, 2002 11:04 AM
To: mrtg at list.ee.ethz.ch; rlambert at noao.edu
Subject: [mrtg] Re: switch


If it is a cisco switch with 48 port cards, they are on the 3rd card,
ports 27,28,29.

>>> ron lambert <rlambert at noao.edu> 06/13/02 10:40AM >>>


I am trying to mtrg monitor a switches ports but an snmpwalk gives

interfaces.iftable.ifentry.ifdescr.123 = "10/100 utp ethernet
(cat3/5)"
interfaces.iftable.ifentry.ifdescr.124 = "10/100 utp ethernet
(cat3/5)"
interfaces.iftable.ifentry.ifdescr.125 = "10/100 utp ethernet
(cat3/5)"
etc etc

So it is hard to to identify what port I'm looking at, as all the
entries give the same 3/5.
Any clues?
tks
ron

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe 
Archive     http://www.ee.ethz.ch/~slist/mrtg 
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org 
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi