[mrtg] VLAN IN/OUT is Blank

[Andres.Tong at jud.ca.gov]

Hello,
When I run Cfgmaker against my Catalyst5500, I get good clean IN/OUT results for
individual ports but
I cannot get IN/OUT for my VLANS. Here is a sample from MRTG.CFG for
IFIndex=179, which is my VLAN3. Will MRTG 2.7.5
extract and graph IN/OUT Bytes for VLANS? It has set the MaxBytes to Zero.  Can
someone help?

########
######## This Interface is one of the following
######## - administratively not UP
######## - it is in test mode
######## - it is a softwareLoopback interface
######## - has a unrealistic speed setting
######## It is commented out for this reason.
########
#
# Target[172.20.0.55.179]: 179:877JDeanisnotgone!@172.20.0.55
# MaxBytes[172.20.0.55.179]: 0
# Title[172.20.0.55.179]: S5B4F3A1 (): VLAN 3
# PageTop[172.20.0.55.179]: <H1>Traffic Analysis for VLAN 3
#  </H1>
#  <TABLE>
#    <TR><TD>System:</TD><TD>S5B4F3A1 in S5B4F3A1</TD></TR>
#    <TR><TD>Maintainer:</TD><TD>JC AOC HELP DESK</TD></TR>
#    <TR><TD>Interface:</TD><TD>VLAN 3 (179)</TD></TR>
#    <TR><TD>IP:</TD><TD> ()</TD></TR>
#    <TR><TD>Max Speed:</TD>
#        <TD>0.0 Bytes/s (propVirtual)</TD></TR>
#   </TABLE>

Andres. A. Tong
Sr. Network Engineer
Network Design/ Internet Security
Judicial Council of California - Administrative Office of the Courts
415-865-7406
cell: 415-819-5459

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi