[mrtg] Re: VLAN IN/OUT is Blank

[Martin Rheumer]

Peoples,

This looks the same as my question about the 6500 series switches
that do the same thing. They get commented out of a cfgmaker run
and then have maxbytes as 0.
There was a cfgmaker.cisco a long time ago anyone got any pointers
to this ?

Thanks

Martin

At 02:04 PM 3/19/02 -0800, Andres.Tong at jud.ca.gov wrote:
>
>Hello,
>When I run Cfgmaker against my Catalyst5500, I get good clean IN/OUT
results for
>individual ports but
>I cannot get IN/OUT for my VLANS. Here is a sample from MRTG.CFG for
>IFIndex=179, which is my VLAN3. Will MRTG 2.7.5
>extract and graph IN/OUT Bytes for VLANS? It has set the MaxBytes to Zero.
 Can
>someone help?
>
>########
>######## This Interface is one of the following
>######## - administratively not UP
>######## - it is in test mode
>######## - it is a softwareLoopback interface
>######## - has a unrealistic speed setting
>######## It is commented out for this reason.
>########
>#
># Target[172.20.0.55.179]: 179:877JDeanisnotgone!@172.20.0.55
># MaxBytes[172.20.0.55.179]: 0
># Title[172.20.0.55.179]: S5B4F3A1 (): VLAN 3
># PageTop[172.20.0.55.179]: <H1>Traffic Analysis for VLAN 3
>#  </H1>
>#  <TABLE>
>#    <TR><TD>System:</TD><TD>S5B4F3A1 in S5B4F3A1</TD></TR>
>#    <TR><TD>Maintainer:</TD><TD>JC AOC HELP DESK</TD></TR>
cut...

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi