[mrtg] Re: monitoring 3COM switches

[Trent Melcher]

Yes it can be done with the standard cfgmaker that comes with MRTG to create
the config files.  Just make sure SNMP is turned on, on your switches, and
that is all there is to it.

Then you can run indexmaker to create the html page to display the charts.


Trent

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Marvine
Sent: Wednesday, November 06, 2002 1:17 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] monitoring 3COM switches



Hi,

I was wondering if anyone out there has managed to monitor 3Com
switches (3300, 1100 ) using mrtg ?
If any, could they give me some address and advice about it ?
`
Thanks

Marvine

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi