[mrtg] Re: Cisco 2610 Frame Relay

[Waltman, Adam]

By IP address.  You can put the IP of each subinterface into your MRTG
config.

-----Original Message-----
From: Matthew Halliday [mailto:matthew.halliday at johnstonpress.co.uk]
Sent: Monday, September 23, 2002 8:11 AM
To: 'Mrtg (E-mail)
Subject: [mrtg] Cisco 2610 Frame Relay



Hi all,

Following on from last week - thanks to all who offered advice.  Our Cisco
2610 is now producing very nice graphs, and providing some very interesting
data that I'd like to analyse further:  On the inside there is a single LAN
connection: ethernet 0/0 , but the outside is split into 3 Frame relay
channels - Sync/Async 0/0.1 - 0/0.3.  I really need to monitor each one
individually to find out who's hogging the bandwidth.   Can anyone offer any
advice as to how to do this?

Matt

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi