[mrtg] MRTG Newbie question...

[Phil Carroll]

I apologize up front as I little knowledge of Perl and am new to MRTG.
 
    I was able to get MRTG configured with the default cfgmaker parameters
listed in the "NT-guide" listed on   <http://www.mrtg.org> www.mrtg.org. It
polls my cisco 3600 and it seems to gather info for all it's ports just
fine. The only problem that I have is that it appears to be a decimal place
off in all the HTML.
 
Example:
 
HTML Report says:  
Max  In:	 544.1 kB/s (4.4%) 		Average  In:	 495.4 kB/s
(4.0%) 		Current  In:	 544.1 kB/s (4.4%)	
 
The numbers should be 5.441 MB etc. The decimal place is off in this manner
on all ports that are being reported on.
 
Also The MAX speeds are all wrong.
 
I have 3 active interfaces:
 
FastEthernet0/0 - 12.5 MBytes/s (should be 100MB)
Hssi2/0 - Max Speed: 1500.0 kBytes/s (should be 12 MB)
Hssi3/0 - Max Speed: 1500.0 kBytes/s (should be 12 MB)
 
    I have read though the online docs and not found any help, If I have
missed docs that can help I would be happy if someone could point me in the
right direction.
 
Thanks!!!
Phil Carroll 

Internet Systems Engineer 

NFO WorldGroup 
2700 Oregon Road 
Northwood, OH 43619 
419-725-8791 

 


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi