[mrtg] Re: MRTG Newbie question...
Brander, Eric
Eric.Brander at ACS-INC.com
Tue Apr 1 17:00:15 MEST 2003
MRTG by default deals in Bytes. If you wish to use Bits as a reference, then
you need to use the bits option.
Eric Brander
ACS
Texas CHIP Account
Sr. Communications Engineer - Information Systems Department
512.336.3331
Eric dot Brander at acs-inc dot com
-----Original Message-----
From: Phil Carroll [mailto:pmcarroll at nfow.com]
Sent: Tuesday, April 01, 2003 8:45 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] MRTG Newbie question...
I apologize up front as I little knowledge of Perl and am new to MRTG.
I was able to get MRTG configured with the default cfgmaker parameters
listed in the "NT-guide" listed on <http://www.mrtg.org> www.mrtg.org. It
polls my cisco 3600 and it seems to gather info for all it's ports just
fine. The only problem that I have is that it appears to be a decimal place
off in all the HTML.
Example:
HTML Report says:
Max In: 544.1 kB/s (4.4%) Average In: 495.4 kB/s
(4.0%) Current In: 544.1 kB/s (4.4%)
The numbers should be 5.441 MB etc. The decimal place is off in this manner
on all ports that are being reported on.
Also The MAX speeds are all wrong.
I have 3 active interfaces:
FastEthernet0/0 - 12.5 MBytes/s (should be 100MB)
Hssi2/0 - Max Speed: 1500.0 kBytes/s (should be 12 MB)
Hssi3/0 - Max Speed: 1500.0 kBytes/s (should be 12 MB)
I have read though the online docs and not found any help, If I have
missed docs that can help I would be happy if someone could point me in the
right direction.
Thanks!!!
Phil Carroll
Internet Systems Engineer
NFO WorldGroup
2700 Oregon Road
Northwood, OH 43619
419-725-8791
--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
More information about the mrtg
mailing list