[mrtg] SNMP Problems after installing a WIC in 2620

[Nate McLain]

Hello List!

I had SNMP working on my 2620.
The unit only had 2 ethernet interfaces in it which connected to my fiber
transceiver. I had MRTG working just fine. And I also use STG traffic
grapher to check my router as well.
After I installed the WIC in the 2620 I am no longer able to get data via
SNMP. I have checked the Cisco config and made sure that snmp was still
enabled and it is. So I shut the router down, removed the WIC and rebooted
the router. And then SNMP was working again.

Has anyone seen this problem before?
Is there some mystery setting that I'm missing.

I know this is more of a Cisco question. Since MRTG is working fine with
just the 2 interfaces.

Any info you can give me would be GREATLY appreciated!!

Nate


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi